Ok so I have the pump plugged into cpu fan, the 9 pin usb plugged into usb910. Cpu q fan control set to dc mode, low limit ignore, fan profile max middle and min set to 100%. Fans are on full blast and Corsair light is faintly lit up. Bios fan profile says cpu fan n/a, chassis fans all working. Still no controls in Corsair link and Universal Serial Bus doesn’t detect it. I have 2 asmedia usb 3.1, 1 Intelr usb 3.0, 3 usb composit drives and usb root hubs 3.0. I don’t know which one it will come up in but I disabled and enabled everyone I can.