danielshaw007

Thanks for that, I have done as said, selected 3 fans but only the fan in port no1 in the hub is lighting up. Edit, sorted it, they were LL fans not ML fans .. Thanks for the advice.

Hi all I have installed the ML120 3 fan pack with the lighting node pro. As per the manual I have plugged the 3 fans rgb connectors into the rgb hub, then the rgb hub into channel 1 on the node pro. Also the 2 sata power connectors are in. In ICUE it can see the node pro but it says no devices connected to channel 1, I have tried the hub in channel 2 and still no devices detected. Fans spin but no lighting Please advise.

Fitted my h150i EC today this is worrying I'll be looking out for any leaks tonight

Hi all. Just installed the h150i elite capellix and I have got an extra 2 ql140s for top of the case. They're connected to the rgb hub that came with the AIO When I set the fans to extreme the 3 on the AIO spin to full speed but the 2 QL140s seem to top out around 800 rpm ish. Is there an issue here? Thanks

Thanks again, I ordered the QL fans as 2 singles to bring the cost down, I should have done some more research lol. I will see how it goes.

I see I totally get the issue now and yes the supplied ML fans will be at the front and I got the QLs to go at the top of the case (4000d airflow) and I plan to get a QL120 for the rear also. I will see how it gets on, if I go down the route of a separate controller for the QL fans, do you know which one I require? Thanks again

Ok thanks, that LED count thing seems a bit of a pain, maybe corsair can fix with a software update one day ?

Hi all Will the icue commander device that comes with the h150i elite capellix work with QL140 fans I have purchased separately ? Thanks

Hi all Can I use the already installed mount/backplate off the H100 pro rgb for my new H150i elite capellix ? Just thinking to save time installing.

Hi there Are there the dummy ram sticks available for the dominator platinum rgb like the vengeance rgb pros ? Reason I ask is i have 2x 16gb of dominator and would like the other slots filled with the same rgb lights. Thanks

Hi all In the market for a new 280mm AIO. Out of the H115i RBG Pro XT, H115i Elite Capellix, H115i Pro RGB or the H115i RGB Platinum Is there one that excells on terms of cooling performance ? Thanks

Hi all I have just got the h100i pro rgb aio to cool my 7700k. Due to my previous h80i seeminly losing efficiency I had been running the 7700k at stock frequency. Im still using stock settings on my 7700k and last night whilst playing Metro Exodus I had coretemp running in the background and the CPU was hitting 90 degrees C I have checked and rechecked the pump is sat true to the cpu and I have even removed the preapplied paste and replaced with the new noctua nt-h2 and still seeing very high temps for stock frequency. I have got icue installed and set the pump and fans to extreme Any ideas as to why its so hot with a bigger AIO, is it possible for one of these to be faulty, have air trapped inside it perhaps? Setup is a NZXT H500 case, the radiator is mounted at the front pulling air IN to the case through the radiator, then I have 2 case fans at the rear and the top setup as an exhaust.

Thanks for your reply says v4.31 on the sticker on the actual modules. thanks

Firstly sorry to admin for double post, realised my original thread was in the wrong place. Hi all I have just bought the CMT32GX4M2C3200C16 kit, and ive read around these are high binned and OC quite well. I had a go with a modest OC at 3600mhz and system refused to POST at the voltage set by XMP. Before I go ahead and raise the voltages, has anyone got any experience with OC on these modules? Thanks :)