andyruk

sounds similar to my issue , fans running just white no colour shift and no hardware showing , i.e. fans , pump ect i have put my pump onto a motherboard CPU header for now just so i know its running

Hello , i have been running with the latest ique software for some time with no issues with 2x Commander ique pros connected and hydro x xd 5 and block , now i have none of this showing in the dashboard , cant see any fans or pump speed i cant add a device other than whats there on the screen , i have tried to unplug the usb headers for the two commander xt pros but still no joy ! any ideas ? regards Andyr

hello , i have 2 x commander pro XT's with 10 corsair sp elite fans and controlling the speed of my corsair pump also , i wondered is there a way of controlling all the colour change shift across the two controllers in sync instead of two blocks ?

Great thanks for you quite response , i will get one and give it a whirl

Hello , does anyone know if the temp sensor that comes with the Corsair Hydro X Series XD5 RGB Black Reservoir / Pump Combo is available as a spare part , its the one that is mounted in the threaded fitting i'm after . thanks in advance Andyr

Hi , I have this case , very well made and i used the water loop configurator and added my components , all worked out ok . https://www.corsair.com/uk/en/custom-cooling-configurator/

Hi , I have just done a new build with a RM850i and have two cables , one is a micro usb which plugs into the power supply the other end is suggested plugging into a usb 2 onto the motherboard , which I have and seems to give feedback for voltage ect when I go into iQue. The other cable plugs into the power supply which is a flat 4 pin but where does the other end go to ? , its too small for the commander pro Regards Andy

Hi , was thinking about doing the same with the gfx card , just wondered what length riser are you planning to use ?