Hey all. Putting together my first build in a couple years and my first using watercooling. I chose the 460x Crystal RGB and the H150i to do a push/pull setup, with two of the ML120 fans as intake on top, and the third as an exhaust at the rear.
Meanwhile, the radiator is mounted to the front of the 460x by way of the SP120 RGB fans that came with the case.
The ML120s are powered from the motherboard, while the SP120s are powered by the H150i. The fans are plugged into the RGB lighting controller on the back in slots 1 - 3. The SATA connector for power is plugged in.
The fans are all spinning, all three of the front ones are working just fine, minus the lack of lighting. In iCue I can set the lighting values for the CPU block and my Vengeance Pro RAM, but the fans are not affected.
Any help would seriously be appreciated!
