Hey everyone,
My setup is H100i Platinum and 6 LL120 fans connected to a commander pro.
Within the Icue software, when I highlight the fans I want to change and apply a manual curve, my fans ignore this and choose to run at about 1300-1400 RMP. I've even set them all at 0 RPM to see if they would turn off but once again, the software ignores this and continues the fans at the speed I mentioned above.
However, if I choose to highlight the fans and set it to a fixed RPM, this works perfectly fine for all my fans.
I have forced an update so I'm on the latest version of the software but I'm really struggling to find a solution to make the manual curve work.
Any help and advice would be appreciated.
Thank you.