Ekyona

I have the mouse pad, headphone stand, the External LED lights and towers, Keyboard and Mouse. That equals 6 USB connections. if I add more I-cue devices. Can I use my type-C and connect a dock for more usb 3.0 connections? or what do you recommend?

it would be the external ones

so I was wondering how everyone connects their icue devices to the pc. I have a wired keyboard headphones; mouse & some external lighting. my motherboard is almost full except for 1 USB port. I'm using a lg as my monitor. can I use the USB ports on the TV?

I want to get the Hydro X Series XD3 RGB Pump/Reservoir Combo. can this pump/Res be mixed with Aluminum Rads? also can Corsair CPU block be mixed with Aluminum Rads?

Bubbles are gone! The air exhaust from bits-power helps.

Thanks! Acrylic wasn’t bad. I would encourage someone new to try it out. Just need a nice “fine” saw to cut and wait like 30 secs to heat it up to bend.

So I’m a idiot.....all I had to do was change the timing. I wasn’t allowing enough time to pass by for the light to work. So problem solved. Hope this helps someone else.. sorry about the post guys.

Hello everyone, I’m sure this has been answered and I just can’t find the answer on the internet. But when where I go to custom>Wave. I choose my color. So wave is suppose to light up one fan then go to the next right? Well mine doesn’t. It just stays within one fan. Everything is update. My bios (Asus motherboard) windows. I guess I could delete my icue? Any advice would be great. Not sure if anyone else has experienced this. Thank you in advance for the feedback

Here it guys the final product. Gpu idles at 28-30 and CPU AVG IS 35. I have a 2080 ti and i9 9900k. I think those are good. It’s winter here where live now so we keep the house at 68-70 F degrees. This is my first ever watercooling pc. To those trying and wanting to do. It’s honestly not too bad. The most challenging part was getting the measurements right when you are bending the tube. I used Corsair hard tubing which is acrylic I think? I did ordered PETG tubing just cause I read negative comments about using acrylic. But I have a bandsaw and it made it easy to cut thru. Bending them was easy, it did take longer to heat the tubing enough to bend. Fittings were easy, it really comes to preference which you use for 90 degree bends. I did the like the 90 degree fittings :) I really have so much to say lol oh I test leaked with EK - AIR PRESSURE GAUGE. I pumped the loop with air and it held a stable pressure. I recommend buying one. Watercooling is a smaller version of plumbing in your house. I will say that cable management is awful with these many fans.... I attached a picture. Still working with the coolers. Oh and it looks foggy cause I have not peeled the plastic of the glass. Let me know what you guys think. And future advice would be great!

Here it is guys finally finished. My only question is how do I get rid of air bubbles? Do I just keep turning of and on?

Thanks again for the advice guys. I’m almost done with the tubing. I’ll post a pic soon. Does anyone use a filter? I saw bits power have one. Does it help your loop in the long run?

Thank you guys for the input. Watched the video so, it made me feel better about my layout.

So I uploaded a picture of the route I will use. You guys let me know if I should change it. Also what is your guys take in having a air exhaust fitting? I’m open to better routes. Any help is welcomed!

Do you know if EK fittings are just as good?

Hey thank you this helps a lot! What is that little screen you have?