Kaelos

Just wanted to come back and provide a quick update now that I have my computer built... My original plan worked perfectly! I have the 3x ML120 and 3x LL120 for my H150i's radiator connected to my Commander Core, and the 2x LL140 and 1x LL120 for the case connected to the Commander Pro (via the RGB Fan LED Hub). Everything shows up and works correctly in iCUE. :)

Actually, I just saw this in the iCUE Elite Capellix FAQ thread: So it sounds like my original plan may actually work if I do need all cooler fans to be on the same hub...? Could always just go with some trial and error in the end, lol. :D

Thanks for the reply. I haven't used Corsair's iCUE software or hubs before, so I was assuming the fans for the CPU cooler would need to be on the same hub for fan speeds to be controlled properly. I did also just find a discussion somewhere mentioning no mixing between ML/LL/etc types. Could I perhaps instead connect the ML fans to the Pro and all the LL fans to the Core, then indicate in the controlling software which fans to tie to the CPU/cooler temperature?

I'm about to build out a new computer using the Obsidian 500D RGB SE case and the H150i Elite Capellix CPU cooler. I was considering using the ML120 fans from the H150i with the LL120 fans from the case together in a push (LL in front) + pull (ML in back) config on the cooler block. I was also then thinking to get 2 LL140 fans to use on the top of the case, and another LL120 for the rear of the case. Looking at diagrams and info in the FAQs here, I know the case comes with the Commander Pro and an RGB Fan LED Hub, and the H150i Capellix comes with a Commander Core. So included part summary would then be: 1x Commander Pro 1x Commander Core 1x RGB Fan LED Hub 4x LL120 2x LL140 3x ML120 (I see the dual packs of LL140's come with a Lighting Node Pro, but I'm not certain that would be needed with the commanders...?) Judging by other diagrams I've seen, I think I could then connect things as: 3x ML120 + 3x LL120 to Commander Core (and the AIO connected here also) 2x LL140 + 1x LL120 to RGB Fan LED Hub to Commander Pro Would this work correctly like that, or would I need any additional hubs of any sort? Thanks!