chainzy

It can't be a conflict as it used to work fine before with Icue installed. I need Icue for my headset and link for the h110i. And if it was a conflicting app it would not work with just a usb cable plugged in.

I've uninstalled and clean installed the latest chipset drivers. No luck. I have a feeling something is wrong with one of the drivers. Device manager shows yellow over USB input device. If I uninstall that and scan for changes it will setup intergrated usb bridge. Then it will work but after a while it will stop or on restart I need to repeat the process over again. Is there a driver file I can try?

So If i disconnect the usb cable from the link controller and plug it back in it will work, but once I restart the pc it stops and I have to do it again. If I run a usb cable from the back of my pc usb ports to the link controller it will work and if restarting pc it still works. Could the original link cable with usb header be going bad?

Oh...I didn't know a single thing about siv and seen a few posts about it being able to check stuff. It's not a SIV issue, thats the only way I've found to get it up and running. Was hoping someone would know what the issue is. Something to do with the intergrated usb bridge keeps stopping or something?

For some reason every time I start my pc my fans wont show up with the h110i and I'll have no control over it. If I open up SIV I can hit the restart button here and it will work then but once the pc it turned off or restarted again I have to repeat.