cocoaboey

Hello. I just put together a new computer, specs in my profile. I have an h150i aio on the cpu. I replaced the stock fans with 3 hd120s. The 3 120s are connected to the fan cables from the h150i. The h150i is connected to a sata for power, CPU fan header and the USB is connected to the mobo. I also have the commander pro to which an hd140 rear fan is connected. The USB for that is connected to the mobo right next to the h150i USB. Now, when I load the iCue software, the commander pro shows but the h150i does not. When I run Asus AI Suite3, it shows the aio pump, set to 100% by default. No fans show in AI suite 3 since they're connected to the h150i and commander pro. I tried switching the USB on the mobo between the commander pro and the h150i, but both mono headers seem to be working since the commander pro always shows up in iCue. I looked at other forum posts about this, but none of the solutions mentioned seem to be working. I do not see the device everyone mentions for the h150i in device manager under the USB section. Any help would be greatly appreciated.

Yes, the two 200mm fans are PWM but also RGB, so I will keep them as they are now. It will be a little out of sync, but they're amazing fans, not worth replacing. That's what I thought. I have my AIO plugged into the CPU fan header on the computer I just replaced. But I figured I'd try this setup this time around and see what happened lol. But based on everything I read online, and your confirmation here, I will move the cables around. Thanks again. I really appreciate your responses.

Thanks. What is the AIO header used for then if you always put the AIO cable into the CPU fan header? So basically I'm going to have just my HD140 rear exhaust fan connected to the commander pro? The CoolerMaster H500M case comes with two 200mm RGB fans that have their own connection on the case and are controlled with the MasterPlus software. I am assuming I can't connect those two fans to the Commander Pro since they're not Corsair fans.

Hello All. I just built a new computer, specs seen in my profile. I am using the Corsair H150i Pro AIO for my CPU. I replaced the rear 140mm fan that came with my case with a Corsair HD140. I plugged the AIO into the AIO header on my mobo, and the HD140 into the CPU Fan header so I wouldn't get the error. I couldn't use the RGB on the HD140 yet because I didn't have the controller. So, I ended up buying 3xHD120s to replace the stock fans on the H150i, and these came with a controller. So I set up the hub/controller (120s slots 1-3 and 140 slot 4). The RGB on the 3 120s works, but the 140 does not. I am in contact with Corsair to hopefully get this replaced. Now to the point of my post. I decided to get the commander pro so I could have some more control over the fans and LEDs. Right now, the 3 hd120 radiator fans are plugged into the H150. The H150 is plugged into the mobo via usb2 and aio. When the commander gets to me on Friday, I have no idea where I should move all of the cables. Do I plug the AIO fans into the commander? And the HD140? And what about the USB2 from the H150i that's going to the mobo? Do I plug that into the commander? And when I take the HD140 out of the CPU Fan header, should I take the H150i cable from the AIO header and put it in the CPU fan header so I don't get the error? Thanks in advance for your assistance!