n0ahg

The power wires just hang out of the end of the video card?

It's now up to cpuid to release a new sdk and for corsair to bundle the update. I'm still waiting for support for my motherboard which was released in oct 2018! I worked with cpuid to add support but it doesn't appear to be in the sdk yet :-(

Still no support for Gigabyte Z390 M Gaming. I worked with cpuid over two months ago to get a beta of hwmonitor to see the montherboard sensors but the support must also be waiting for a sdk update :-(

Did you come up with a solution for this?

I have almost 11 cm the width but the problem would be the height. The cable management bar would prevent installation on bottom fan and only allow about 120mm height from the bottom of the top fan. The option might be to remove the cable management bar as it's an all black case. The RTX 2060 FE can be dismantled, I've seen that video which is why I knew about the glue, but I don't think you can get a water block for it due to the difficulties and because it doesn't run that hot (160W with only one 8 pin PCI-E to power it). The fans on my second card still make an annoying noise though (RMA'd one already due to fan noise) :-( Edit: Oooops, only 11cm width... that would be including the radiator so no go. Edit2: I've found a water block and the glue looks like it's just for the ribbon cable so not too bad, none is left holding the actual card after the ribbon cable is removed.

Try HWMonitor as it uses the same code cpuid sdk is based on to see if upcoming support is being added. I was in contact with one of their devs and he added in support for my gigabyte z390 m gaming motherboard (released Oct!) in a test build which will everntually be rolled in to cpuid sdk so anything using the sdk will benefit (iCue, 3d mark, etc.)

Currently have a RTX 2060 FE in there so can't watercool the GPU as it's glued together :-( What are the physical dimensions of the XD5 including the distance from a radiator when mounted? The H400 has a little bit more space if you switch the fan mount round the correct way as shown in the manual as they come fitted back to front! Also the cable management bar can be moved to it's rear position with my GPU.

Would would the fit be like in a NZXT H400?

Does hwmonitor (https://www.cpuid.com/softwares/hwmonitor.html) list the sensors? This is the reference for the hardware detection library. They have a process where you can report missing hardware.

I believe the update is for Hydro X support so you won't see any differences unless you have that hardware.

This doesn't work on my Gigabyte Z390 M Gaming. I see the motherboard panel in the dashboard but it is empty!

Any update on this issue as the latest release of iCUE doesn't resolve it and no motherboard sensors or fans are displayed in the dashboard motherboard panel? I can't wait any longer to buy my water cooling gear for my build. Do I chance that Corsair will ever resolve this issue or do I spend my money elsewhere and dump the corsair gear I have already bought? My finger is hovering over the purchase of the Hydro X kit but I need the software to work with my motherboard (which was released in OCTOBER!)

Still no support for Gigabyte Z390 M Gaming which came out in October!

Exactly, that's why it allowed us to pinpoint the error to the CPUID SDK and is why I've logged a report with CPUID. :-)

No conflict can occur if you use the portable versions and only run one tool at a time ;-)