Viper4060

Bump. Still missing as of iCue 4.20.169

They will never add the argb headers. They even said so.

the latest icue version has removed the two sides toggle from the commander core/elite capellix. Thankfully I have my profiles saved, and two sides waves still function. (please don't remove this feature)

Bump, would like a response on this.

From what I have seen it's just the pump led orientation 'preview' within iCue it is correct as it is the same direction as the H100i plat on the pump itself. With the pump oriented with the tubes on the right side like it should be, and set a two sides wave of the outside border it will show the wave starting at the top right and going down and to the opposite corner in iCue preview. It should be 90 degrees rotated to start at the bottom right in the iCue only, this is what the platinum and elite series cooler actually do IRL. Nothing needs to change firmware wise. Unless we can get the option to rotate the cooler leds in software. I can post a video of what I mean if needed.

I am interested in a 140 ML RGB from the elite coolers as well for my rear exhaust.

Yes, that is exactly what I am saying.

I would double check the sata power lead going to the h100i, do any leds light up on the pump/block top?

Actually went ahead and did it now, it forces all fans to be set the same, however you can always set it to whatever the highest number of leds in your fan is example LL are 16 led. Then just use the leds that work on that fan like this is for my ML120 4 led for example instead of the 8 led ML120 that are from the 150i elite.

I believe it forces every fan to be the same led wise. I will test later with my ML PRO 120 4 led from my h100i plat

This isn't a Commander Pro, its a Commander Core made specifically for the Elite coolers, you can't change the PWM settings.

Correct they cannot, however if you really want the ML Pro fans with rgb you can buy the ones from the H100i/H150i Platinum. a

I would try first powering off the system then turning of the psu let all power out of the system, see if all the fans spin while not in os. If then it doesn't show in icuem I would try re running the firmware update.

You are correct.

The 4 pins are for the rgb fans, yes the 3 pin goes in the cpu fan header for pump RPM only so you don't get CPU Fan Error, you will not be able to control the pump speed though your mobo, you have to use the usb connection on the side of the cooler for pump speed.