DanielDC88

I have a cable through my wall to my VR area. When I play VR I need as much performance as I can get. To do this I apply an overclock and set my fans to 100%. In MSI afterburner this can be applied to the GPU using a shortcut. On iCue I have to faff with its questionable ui for a bit. Is there a way to programatically control these settings? Either via hotkey, cmd command, opening a file... something I can automate? Or is this a fully manual affair?

The noise of the cooler trying to start my noctua fans from 0RPM is really annoying, and at their lowest speed the fans are inaudible over even the pump. I'd like to stop the fans going to 0RPM, but the software only works in percent. How do I configure this? Thanks!