I went to drain my loop today in order to change up some fittings today, went to refill the loop and noticed that my pump would not run at 100% using my 24-pin jumper, so my loop would not fill up. Every time I flipped the PSU switch, it would run 100% for about 2-3 seconds, then run slow.
I had no choice but to boot the system up while slowly filling my res so when iCue loaded, if my pump was still alive, it wouldn't suck in air and overheat anything. My pump came alive again after I set the pump to 100% duty cycle.
To test an idea, I left it that way in iCue and rebooted with my jumper. And the pump ran at 100%.
So does the CPro run pumps based on the last known config it was set to in iCue? Why does it do this and is there a way to disable this so I can leave it on my normal profile and not need to remember to switch to my 100% profile when I want to drain and refill?