Trick0502

That’s your best bet. Corsair doesn’t seem to be doing anything about this.

This isn’t normal for aios in general, but it seems to be normal for this model. I would look for an aio that doesn’t have a coolit pump. Look for ones with asetek pumps.

I don’t know how Corsair claim 20db in quite mode.

Am I right that there is nothing that can be done about the pump noise? If so this thing is going back.

Same as above. I have to rip this out of my system and return it. My h100i v2 (precious cooler) was silent at idle. $200 piece of junk.

I’ve owned h50, h55, h100, h100i and a h100i v2. The only one that was close to this loud was the h100. The h100i v2 was just taken out of the system for this cooler. I can tell you that you couldn’t hear the pc at all over room noise. I can hear this h150i as soon as I walk in the room. I would love to see their testing where the pump is 20db. Corsair do you have a video of this?

i have 6 ll120's at 600-700, 3 120's at zero, the psu has zero rpm mode on and the pump. all the noise you hear is the pump. if this cant get fixed it is going back. using a sound meter it is 40db. trash. [ame] [/ame] LOW-NOISE CENTRIFUGAL PUMP Delivers a flow rate of up to 0.82L/min while generating less than 20 dBA, for extreme cooling with low noise.

that is correct, it is always 100%. even if i just use a 24 pin jumper. is there anything i can do on my end to fix this?

for some reason the fan on this psu always runs at 100%. this is the newer (2018?) model with the white sticker on the side. i connected the 24 directly to a jumper and it still ran at 100%. i will upload a video later today. anyone have anything i can try?

This was working great about two versions ago. Now it is a total mess. It crashes constantly and causes my mouse not to work. And now my fans just ramp up and down as they show and disappear in icue. Any ideas? I will post a video in the morning

bump same issue. anyone got a fix? asus x470 prime

I am also having this issue. I have an Asus x470 mb. What setting should I be using to get the hub to work on the commander pro?