kyriac05

Please can someone assist? Thanks

Is anyone able to assist pls? All of a sudden, my iCue doesn’t work and as a novice, I’m really struggling. Thanks

Hi - hope someone can assist. This morning, I went through the steps to install ASUS AURA and thhe plug in so I was able to configure my Prime Z390 A MB withj ther rest of my Corsair RGB. After a few goes, it worked, and I quickly linked the MB to all the other RGB I have (Fans, RAM, Cooler). However, upon turning my pc off, and then back on again, iCue did not start, and when I tried to, all that showed in the top right corner was the iCue home screen WITHOUT any of my devices. After a minute of it hanging, it kicks out. Please assist!

Seems like we have an issue as now I have Cooler showing (although lighting appears temperamental and no fans showing. So I have an issue with one of the USBs on ComPro then. Can I use another UsB anywhere then?

Thanks guys. Will try and revert.

Hi To confirm what you mean, the Coolers USB that comes from the left side of the cooler as you look at it, I’ve connected that to one of the USB ports on the ComPro. Are you saying I merely connect it to the other USB on there? If so, that means just swapping with the Lighting Core USB that’s in there? Thanks again

Many thanks. I’ll give the above a try later and confirm back. Appreciate your reply.

Hi I’m new to this so need some advice post my first build for my son. I have 6 LL120 fans, two of which are attached to my H100i radiator at the front of my 465x case. In terms of set up, I’ve attached the cooler to the CPU FAN on the MB, and the two cooler fans power supply attached to the accompanying connectors that come with the cooler too. (Fans 2 and 3) The other four fans power is connected to the Commander Pro. (Fans 1, 4, 5 & 6). The RGB for all 6 fans are connected to the Lighting Node core that comes with the case. This has meant that my ASUS Z390 BIOs only show the RPM of CPU FAN obviously and is showing at around 4500 (which is the cooler). Is this ok? I have no idea so would appreciate some feedback pls. Re iCue, all fans seem to work fine and in the order they should but I can only see fan RPM of the 4 connected to the Commander Pro. I also cannot change the RGB on the cooler. It’s lit up at the default Rainbow and is showing in iCue but only next to my Vengeance RGB RAM and not as a device in its own right. I also cannot click on it. Many thanks for reading and as I say, I feel it’s all correct but am a complete novice and would appreciate some clarification. Thanks

Hi - Hoping someone can assist pls? Bought my son the following for our firs build: 465X Case with 3 LL120 fans and Lighting Node Core 1 additional LL120 RGB fan H100i RGB Platinum AIO cooler 2 x 8GB RGB Vengeance RAM Given the RGB parts above, will I need more than the Lighting Node Core - ie the COMmander Pro? Thanks in advance

Hi - I'm just creating a build for my son and need some assistance pls. Re Corsair RGB I have: H100i AIO Cooler (comes with 2 LL120 fans) 4 further LL120 RGB fans (3 come with the 465X case, other I bought separately) Vengeance RGB RAM 2 x 8GB DO I need the Commander Pro to work the above or will the Lighting Node Core that comes with the case suffice? MAny thanks