I have finished installing the bracket with an H75 in my Corsair 250D ITX case.
Installation finished without a hitch. I noticed a slight bit of board bending once I installed the 5 bracket screws but nothing I would consider worrisome. I used the Intel bracket already attached to the H75. I DID NOT tighten any bracket screw with any significant amount of torque. I did however tighten the cooler screws in an alternating diagonal pattern until they were pretty snug. I'm not sure if the screws are tight because they hit then end of the stand-offs or because the cooler is snug against the chip but the temps seem to be fine.
My idle temp is 36c and running The Witcher 3 on Ultra at 100+ fps with a +150MHz GPU offset o/c the temp maxing out at 60c. So far I have not been able to increase my o/c settings without having my GPU drivers failing regardless of its temp which is kind of a bummer. Silicon lottery thing I guess.
I should mention the blower fan is not making much noise and so far has not sped up during high load. PrecisionX keeps it at 1627rpm. I am not sure this is or will be an issue.
The H75 fans are plugged into the H100i pump. Everything is recognised in Corsair Link.
