Morrosis

Yeah so, I put one of the fans to the fan controller moved the other fan to the 4 pin header and it is now working in icue https://imgur.com/a/pv3YxFl Thanks for the help

Thanks, I also removed the link software as well and installed icue as a test https://imgur.com/a/rYDeOyc The fan still showing as 0 RPM, but running at 100 percent, I can not change it at present in the icue software, yeah I have 4 fans all the same in my case, I will swap the fans around a check the 4 pin header on the cable as well to make sure it is all working. Thanks for that

Hi, Noticed in the link software that the fan RPM for my H80i is 0, I opened my case and the fans were spinning but would stop. I disconnected one of the fan from the y cable and plugged it into the fan controller I have so I at least could make one fan work constantly. The Pump for the cooler is at 3000 rpm, I also double checked my bios to make sure that the fan controller was set to 100% full speed thinking it might be the 12v issue, though from what I understand that would also mean my pump would only operate at 600 RPM. If I manually change the fan profile to max, I can hear the fan spin up and run at max speed but the software still only shows at 0 RPM. Given the Pump is working at 3000 RPM and the current temperature of the system I should be safe to assume that the cooler is still pumping liquid around? https://imgur.com/a/FUtnulK Regarding the fan header, what would be the best course of action? My H80I was purchased in 2017, so it should still be in the 5 year warranty period, so do I just take it back to place of purchase or do you have any test I can run before hand?

Hey, Just installed the iCUE software, how do I copy a profile from my H80iv2 to my commander pro so all the fans spin on the same curve? Also how do I add more points to a custom curve?

I thought iCUE was just for RGB stuff. I will switch over now and give it a go.

Hi all, I have a Commander pro and a H80i v2, all the fans are Noctua NF-F12 Industrial PPC and I have two connected to the Commander pro and the other two connected to the H80i, and it connected to the commander pro as well. At the moment the case fans as you can see in the image are not spinning at the same rpm as the H80i fans. Is there a way I can link them to all spin at the same speed and profile? I tried setting them all to the same group that being the H80i v2 group but the profile for the quite mode is different as seen here for the case fan and here for the H80i any help would be nice Thanks Morrosis