kndll
Members-
Posts
16 -
Joined
Reputation
10 GoodAbout kndll
- Birthday 10/07/1969
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
-
icue integrations Nanoleaf Smart Lighting Comes to iCUE
kndll replied to Corsair CJ's topic in CORSAIR iCUE
got mine to connect , ICUE sees the Nanoleaf Shapes but has no effect , will not control them . -
icue integrations Nanoleaf Smart Lighting Comes to iCUE
kndll replied to Corsair CJ's topic in CORSAIR iCUE
I cannot get my Nanoleaf shapes to pair , Icue does not see Nanoleaf , and Icue will not connect to the ip address through manual pairing , any ideas ? -
i could not get 4.16 to install either , so i tried 4.17 same problem just hangs , still on 4.15
-
kndll started following CORSAIR iCUE
-
kndll started following Brightness Dark Core RGB Pro , Introducing the new CORSAIR iCUE (v4.X) - Megathread , thread to find replacement for icue and 1 other
-
check out Signal RGB
-
Introducing the new CORSAIR iCUE (v4.X) - Megathread
kndll replied to Corsair Nick's topic in CORSAIR iCUE
ICUE also thinks my Lighting Node Core has a thermal probe attached , asking me to set up Hydro X custom cooling ! -
Brightness Dark Core RGB Pro
kndll replied to Vanadiel's topic in Gaming Peripherals & Audio Troubleshooting
I searched for this same problem , i don't know where i found the answer BUT UNFORTUNATELY the Dark Core RGB Pro is full bright or off ONLY !!! -
Not sure if you can reassign buttons on the Dark Core RGB Pro , it has dedicated DPI buttons beside the left click button , middle button is for changing ICUE profiles .
- 2 replies
-
- button mapping
- button push color
-
(and 2 more)
Tagged with:
-
Exasperated. Bit of help please with my QL/H100i setup.
kndll replied to jtuds's topic in Build Hardware Troubleshooting
The easiest option is #4 , that's the set up i have , QLs and LLs have to be on separate controllers to work -
Why not top mounting?
-
you can turn on/ off leds by clicking on individual leds , you hold down control while clicking with your mouse to turn on multiple leds , you can have a pattern on the front of one fan and same pattern on back of another fan , possibilities are endless when turning on /off leds
-
create a new profile , under lighting channel click + sign , pick your pattern, click and drag mouse over a single fan , click the + sign under lighting channel , pick another pattern , click on another fan , and so on , I have a colour shift profile with six color shift patterns --- one for each fan , this makes the color shift different for each fan .
-
Lighting Link. Visor and Color Wave modes with case on the left side?
kndll replied to ICaRo81's topic in iCUE Software
Too late for me as I had to remove and install 3 of my 6 fans so they would match , they were installed as to where the cables had to go it would have been nice if the fans were marked or mentioned in the instructions Corsair !