Jump to content

Thesebones

Members
  • Posts

    6
  • Joined

Reputation

10 Good

Converted

  • Interests
    Play games build stuff

Converted

  • Occupation
    Pipefitter
  1. I am setting up a custom water loop using an xd5 pump ,finding it hard to find out if, what I want to do is run the pump pwm line from my strix rz5700xt fan header on GPU since I can set this to run off GPU temp and power the pump from the molex connection,a few I asked said it would draw too much power from the gpu I thought the pump draw was from molex and pwm line was for rpm and signal ,any help would be nice
  2. Sound from cooler fans not an issue as one rig has 8 total fans second has 11 fans in case
  3. I put 6 ql's into my new build all work fine.i notice one off end fans shows pong reversed on fan LEDs but gate,infinity and rest show properly with fan in the same position
  4. Are fans plugged into 1,2,3 on controller
  5. I was wondering if there would be any advantage of setting up push/pull on my h100i platinum,of two rig I built first has ll fans in push/pull,and new I put together has the ml fans that came from both coolers
  6. Thesebones

    Fans setup

    A quick question on rad set up upgraded to h100i platinum but used ll fans set up in pull/push on intake in front of case using top 2 of 3 fans bottom fan sngle.and 3 as exhaust 1back and 2 top.i did not use supplied ml fans and kept all 8 fans in case all ll fans(6 on rbg hub and the 2 pull fans off cooler fan control of the 6 speed controled off chassis 1 ,2 and cpu opt .my question will this work as well tho not using the supplied static pressure fans that came with cooler
×
×
  • Create New...