Jump to content
Corsair Community

How can I force my LNP channels to be in sync?


GeneralChaos

Recommended Posts

So I have an LNP with 4 LED strips on channel 1, and 4 fans on channel 2 (using a hub).

 

Ideally, I'd like to use the the sequential channel effect, but when I set both channels to that, they seem to run independently of each other, and I end up with two separate sequential runs going.

 

I have used the config to lay out the order of my fans and LED strips in my case, but that didn't seem to fix anything.

 

Is there a way to have one single sequential channel effect going for both channels at once?

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...