speedhaxu Posted July 26, 2019 Share Posted July 26, 2019 I have a Commander Pro and a Lighting Node Pro. The Commander Pro is connected to the motherboard via usb header, and the lighting node pro is connected to the Commander Pro via usb header passthrough. I'm using the 4 LED strips included with the lighting node pro, and two of the strips are connected to the Commander Pro, and the other two are connected to the Lighting Node Pro. All 4 LED strips are lit up, but my iCUE only detects my Commander Pro, and thus I'm allowed to change two of the LED strips, but not all four. Can someone please help me figure out why iCUE is not detecting my Lighting Node? P.S. I have a H150i water cooler, is this also supposed to be detected by iCUE? Link to comment Share on other sites More sharing options...
Krokarn Posted July 26, 2019 Share Posted July 26, 2019 Have you powered the Node PRO with Sata Power from PSU? Yes, the H150i should show up in iCUE. Link to comment Share on other sites More sharing options...
c-attack Posted July 26, 2019 Share Posted July 26, 2019 The H150i needs its usb 2.0 connection as well to be visible. Try plugging the LNP and H150i into another usb 2 port to see if the problem is with the pass through on the Commander Pro. I would also start a formal Support Ticket with Corsair now. Use the link at the top of the page or through the main website. Link to comment Share on other sites More sharing options...
Sacco Belmonte Posted July 26, 2019 Share Posted July 26, 2019 Did you setup your devices on the "Lighting setup" on your commander pro? Link to comment Share on other sites More sharing options...
Recommended Posts