c3k Posted February 18, 2020 Share Posted February 18, 2020 Folks, My H110iGT pump is making noise. According to the iCUE Devices page, it's pumping at 2353 rpm. I'd like to change the pump speed. I have NO IDEA how to do that. It is not obvious. If I click on the pump speed ("Pump #1";"Quiet"), I do not get any kind of options to adjust speed. (I think there may be air, because it almost sounds like a rhythmic burbling. If I can change the speed, the sound may go away.) I do not mean to get into a debate about the iCUE control scheme. I just cannot figure out how to adjust the pump speed. (Or the fan speeds for that matter! ;) I set this up about 3 or 4 years ago and have forgotten whatever magic I learned to do it the first time.) Thanks for the assist. Ken Link to comment Share on other sites More sharing options...
DevBiker Posted February 19, 2020 Share Posted February 19, 2020 Click the desired Preset. Then click the pump. You should have Quiet and Extreme (or Performance). There will be two for that cooler, IIRC. Those will be the only ones that you can apply to the pump. 1 Link to comment Share on other sites More sharing options...
c3k Posted February 19, 2020 Author Share Posted February 19, 2020 Click the desired Preset. Then click the pump. You should have Quiet and Extreme (or Performance). There will be two for that cooler, IIRC. Those will be the only ones that you can apply to the pump. I bolded the part that saved my sanity. THANK YOU! (I'm sure Corsair made a good decision to keep users from messing with the pump with their own curves.) Ken Link to comment Share on other sites More sharing options...
Recommended Posts