Ganjahouse Posted September 14, 2020 Share Posted September 14, 2020 Good afternoon I hope you can implement an option to sleep LEDs when the screen goes into sleep mode after 15 minutes. My computer is working at night and I would like that when the screen goes into sleep and turns off, so does ls100. I think this option will be very well received by the entire community. Link to comment Share on other sites More sharing options...
Corsair Employee Corsair CJ Posted September 15, 2020 Corsair Employee Share Posted September 15, 2020 Thanks for the feedback. Currently you can emulate a sleep mode by setting hardware lighting to all black on the LS100 controller in iCUE, however this only kicks in when your PC is locked, in sleep mode, or off. I'll suggest sleep tied to monitor states to our product team as a possible future enhancement. Link to comment Share on other sites More sharing options...
Ganjahouse Posted September 15, 2020 Author Share Posted September 15, 2020 Thanks for the feedback. Currently you can emulate a sleep mode by setting hardware lighting to all black on the LS100 controller in iCUE, however this only kicks in when your PC is locked, in sleep mode, or off. I'll suggest sleep tied to monitor states to our product team as a possible future enhancement. Thank you very much for your answer, this option is not valid when the device is active and the screen is off. I already have the hardware lighting black, but it does not solve when the computer is working and the screen goes to sleep. Best regards Link to comment Share on other sites More sharing options...
Corsair Employee Corsair CJ Posted September 18, 2020 Corsair Employee Share Posted September 18, 2020 Thank you very much for your answer, this option is not valid when the device is active and the screen is off. I already have the hardware lighting black, but it does not solve when the computer is working and the screen goes to sleep. Best regards Understood. This isn't automated, but you could also create a custom profile specifically for times when you'll be leaving your PC unlocked and working for extended periods of time. Just set the lighting for your LS100 controller to black/off in that profile. Not the most graceful solution, I know. But it would work as long as you remember to switch profiles before leaving your PC for the night. Link to comment Share on other sites More sharing options...
Recommended Posts