Taahrii1337 Posted March 22, 2020 Share Posted March 22, 2020 So i recently (yesterday) dove into the HydroX series of products and set up a custom loop. So have everything set up and i love it. But here is my question. I have two Commander PRO. The first one Commander PRO(1) has my pump in port 6 and 5 120ML fans connected to it for the 360 and 240 rads. my second Commander PRO has a 120ML rear fan and a 140ML for the bottom rad. In the Commander PRO(1) everything was set up for HydroX. Is there any way to set the 2nd Commander PRO fans setting to HydroX as well or to have it mirror what the first does? It looks weird when some fans are spinning and other are not. Thanks in advance for any help with this! Link to comment Share on other sites More sharing options...
Zotty Posted March 22, 2020 Share Posted March 22, 2020 (edited) Hi Budddy You might find you are better making your own curves and getting it all to match that way imho... i chose to use PWM repeater hubs rather than multiple Commander Pro's in my build... http://i.imgur.com/Q2bE2bml.jpg by using the PWM hubs it allowed me to control the rad fans in groups,,, Edited March 22, 2020 by Zotty Link to comment Share on other sites More sharing options...
Caedhros Posted March 22, 2020 Share Posted March 22, 2020 In my setup I just used one of the LED outputs on the 2nd commander pro that was unused as a hydro x cpu block, gpu block/pump and then it lets you use the hydro x pump/fan profiles on that one. Link to comment Share on other sites More sharing options...
Recommended Posts