Jump to content
Corsair Community

PC wont turn on with corsair lighting node pro


The Vex

Recommended Posts

I have a 3 pack of the corsair ll120's, once i hook up the sata power from the corsair rgb fan hub, the sata power for the lighting node pro, and the micro usb from the lighting node pro to motherboard (usb 2.0), then the pc will not power on whatsoever. Only 3 connections. Once i unplug the 2 sata power connections and usb cable from the lighting node pro the pc powers on. Any suggestions?
Link to comment
Share on other sites

If you just unplug the SATA (and not the USB), does the system boot?

If so, then you are probably triggering short circuit protection. This can be caused by using incorrect cables with a modular PSU. Keep in mind that you should only use cables that came with or are certified for a particular PSU; you cannot mix and match them.

Link to comment
Share on other sites

×
×
  • Create New...