Jump to content
Corsair Community

Corsair Harpoon not starting right away when Windows 7 booting to Desktop !


GunsR_Us

Recommended Posts

After my old mouse not working anymore, so I decide to replace it with a brandnew Corsair Harpoon (Wire), plug it to the old mouse USB port directly on the Maximus VII Hero mainboard. My Windows 7 recognize The Corsair Harpoon quickly, and it working just fine like the other mouse I have in the past.

 

But the problem is, I shutdow my PC and the next everytime I turn my PC on again, after Windows booting up to desktop screen, my mouse seem not response for about 5-10 seconds without lightning on the Corsair logo. After that the lightning is on and my mouse seem ready to begin to work.

 

I try plug it to another PC with Windows 10 and it work normal, response right away.

 

I've been trying multiple solutions for 3 days, mess up with my HID driver, USB driver and end up non of those can help.

I've installed and reinstalled Corsair Link 4 and iCUE for couple of times.

Also try to plug the mouse to all of my PC's USB port.

And the problem still present.

 

P/S

I feel like Windows take 5-10 seconds to rerecognize the mouse, or the mouse just take it time to decide with driver suit it to work, I don't know !

Edited by Guns*R_Us
Link to comment
Share on other sites

  • 2 weeks later...

similar issue here.

windows 7

working fine until last .

 

CRP DISABLD popup show every time I plugged the Harpoon RGB mouse.

Mouse has no light. PC(and also iCue) could not detect the mouse.

 

Also tried these

-uninstall and then reinstall iCue to the lastest version(3.19.120).

-Plug and Unplug, even try different USB ports.

The problem still occur.

 

I found that if I plugged the mouse and then boot my PC,

my PC takes a lot of time to start windows.

Link to comment
Share on other sites

×
×
  • Create New...