The Corsair User Forums

The Corsair User Forums (https://forum.corsair.com/forums/index.php)
-   System Builds, Modding, Custom Components, and Picture Gallery (https://forum.corsair.com/forums/forumdisplay.php?f=174)
-   -   RM650x - Some Cables Missing Pins. Normal? (https://forum.corsair.com/forums/showthread.php?t=185403)

michicago44 02-12-2019 07:37 PM

RM650x - Some Cables Missing Pins. Normal?
 
Hi all,

First time builder here. I set up my build yesterday and plugged everything to the PSU and was able to use my PC fine for a few hours. However, I noticed on a couple cables that pins were missing in the ends, and no wires were being fed into them. Just want to make sure that's intended.

The two I notice that are missing pins are as follows:

1) The PCIe cable that plugs in to my GPU (the weird looking one that splits into 2). The 8-pin end that plugs into the PSU (says "Type 4" on it) is missing the lower left pin/wire, yielding 7 pins in an 8 pin slot on the PSU. There is also a much shorter 6+2 end (says PCIe on the 6 pin part) that when combined would be not missing a pin. I'm wondering if I should use that end instead of the 8 pin.

2) The peripheral cable that plugs into my HDD, fans, etc (the one with multiple SATA connectors on it in series). The 6-pin end that plugs into the PSU (also says "Type 4" on it) is missing the bottom middle pin/wire, yielding 5 pins in a 6 pin slot on the PSU.

Again, everything was working fine when I tested it out, and I can't imagine these are defects. I've searched around and got mixed results with similar posts - some people saying it's fine and others being skeptical.

Any help would be appreciated. Thanks!


All times are GMT -4. The time now is 09:24 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.