I am at a loss. I completed my build last week and I’m still not fully operational although I've been reading and watching dozens of articles to avoid begging for help... but I am now, here I am asking for your help.
The below build is a bit of a Frankenstein, but it's me doing upgrades
All the below Corsair products are powered and controlled by (or supposed to be) the Commander Pro and iCue
So far, all I’ve been able to accomplish the following;
Mouse, ram and a lighting node shows up in iCue Got all 5 fans to run Got 3 of the 5 fans to have RGB
What I haven’t been able to accomplish is
Get ComPro to even be seen in iCue Get the pump to function with ComPro, get the pump to have RGB and be seen in iCue
2a. Get sensors for pump to work RGB on other 2 fans to work Have ability to control fan speeds, ability to control pump speeds Have any enjoyment at all out of my creation
I’ve tried the following;
using different USB slots add additional lighting nodes and daisy chaining the two fans separately Uninstalling completely the iCue software and reinstalling. Drinking
I've only succeeded at one of them.
The CPU Cooler is the HydroX XD5 Water Pump/reservoir combo.
I’m at a loss now, I've called out to support, but after mentioning my issues, I was told that because it involved the XD5 Water Pump, another specialist would contact me and it would take 1-2 business days. After 2 business days I sent an email and the response was a rep will be another 3-4 business days.
I would greatly appreciate if anyone could help shed some light on any of these issues or to tell me a way to test to help narrow down what’s going on here.
https://pcpartpicker.com/list/dTfQcq