Search the Community
Showing results for tags 'cp'.
Found 3 results
-
I am not sure if I have a faulty commander pro or not but I'll try and explain my issue. I have 2 lighting node pros connected with 8 rgb fans. 6 in 1, 2 in the other. I have the CP and 2 lighting node cores hooked up to SATA and the 2 Lighting node cores plugged into the CP. The CP is hooked up to my USB on my motherboard. The issue is ICUE does not detect either of the Lighting node cores plugged into the CP. I took one of the Lighting node cores and plugged it into my Mobo and ICUE detected it. So do I have a ****ty CP? And for a solution, should i just get a MOBO USB splitter and plug the 2 lighting node cores into the MOBO bypassing the CP.
-
ok.. Im so lost in config and ... corsair .,.. MY setup... CP>HUB>3 HD120 + 2 X HD140 I have done the setup correct, thru some diagram here on the forum. I have tested each fan, they all lid up in port 1 on hub I have tested 3 HUBS I have filmed the entire "check connections, stop / start service"... blabla... [ame=https://www.youtube.com/watch?v=YYriuAtCSa0]filmed it all[/ame] I have a new CP from RMA somebody help me...coz im lost.. give me a yell / PM/ something if you need more info debug export and config in zip... Service_Error.log corsair export debug.zip
-
First i'll start with an apology if this not the correct area but i cant find a specific discussion for CP. Installed CP today to get away from using Asus AI Suite for case fan control and use iCue. I have H150i pro and LNP connected to my CP. I can control the fan speeds fine for my H150i and LP works fine too. My fans just run at full speed through CP. I've tried the following: Force updating firmware (v0.9.212) - It hangs at 0% constantly Reinstalling iCue (v3.26.95) any help/advice would be great Cheers,
