jc2606

Literally the exact same setup as mine. I built in the Corsair 5000D with the white h150i capellix aio/LCD upgrade kit with 6 push/pull fans plugged into a splitter on the motherboard - works fine. Then my commander core xt which has 6 fans for intake plugged directly into the motherboard, but not showing in iCUE at all. Before I installed the LCD upgrade kit it was there, but now it isn't. I've tried updating my bios and drivers but nothing. Come on Corsair, find a fix for this because there are so many people who have this same issue.

Update: I’ve just tested both the CPU fan and pump headers and they both work perfectly well, but when I plug the aio into it, it doesn’t run. I even tested plugging the aio into a sys fan header but still reports 0 rpm everywhere I place it. I can conclude, aio pump has died in not even 3 hours of use.

@Corsair Blade Things just escalated quickly. I followed each of the steps above, minus the one about plugging it into another pc since I don’t have another Pc, to no avail. I uninstalled Corsair iCUE following the steps above and replaced the LCD screen with the original capellix pump head. Strangely there was no lighting at all like it was not receiving power. I checked all the connections and they were fine. After booting into windows the fans went full tilt. I checked my cpu temps and it was at 100 degrees. The Commander Core was not showing up in iCUE and it was defaulting to the hardware settings. To simplify: The pump is not spinning, the capellix was not lighting, and the commander core is not showing in iCUE at all after several restarts and a fresh reinstallation. For Corsair products I’m quite disappointed by how difficult this is. It should be plug and play, but instead it’s going completely awol and it seems to be happening to many many people.

I've built a brand new rig today with the Corsair h150i Capelli + LCD upgrade kit, but the LCD display isn't working. Currently it is just showing a red triangle with an eclamation mark. When the PC boots, it loads normally for a couple of seconds, showing the corsair boot animation and briefly showing the temperature at 0 degrees before becoming what it is. At first it at least showed the LCD screen, but after fiddling about (removing it to install the capelli version first and updating firmware before reinstalling lcd), it was completely removed. It used to show up in the iCUE software but wouldn't have an option for the screen settings. I searched around and saw people suggesting forcing firmware updates, which I did, but they only failed. Upon restarting after force updating the firmware, the LCD would properly show in iCUE, but then my Commander Core T wouldn't show up which meant I had no PWM or lighting control over the front intake so they were running at ma speed and rather noisey. I've tried swapping the USB connectors around and tried using splitters, but my motherboard only has two USB slots and I need three to account for the two Commander Cores and the LCD screen. Please reply with feedback to resolve this problem once and for all, otherwise the AIO just ecessively epensive for something without the screen. Note: My >< key doesn't work (ecks) - sorry if it makes it hard to read bits. Setup/LCD Display & iCUE: https://imgur.com/a/ybW0Bt8