Dfich

Rewired everything to the commander core and everything is perfect now. Temps are 10c better aswell so I guess like you say everything was running the same. Thanks a lot for your time mate much appreciated 🙏

Just a quick question, I'm assuming the best way to set this up correctly would be the plug pump tach into cpu fan header, then the 3 front case fans and 3 rad fans into the commander core and set curves in icue? I've been researching the forums and this seems correct but then I also see conflicting setups on other sites.

Perfect, this is why I was trying to set the curves on the rad fans. Thx for the info much appreciated

Thanks for the info mate much appreciated. This is the weird thing, I've got 7 case fans and there's only 3 plugged into commander core. Setting each channel to 100% cha1 sets all 3 fans to 100, cha2 seta rear exhaust and cha3 only sets the centre fan on the rad. I suppose this is what I get for being lazy and not building myself although pc specialist are meant to be "reputable". I'll strip it down later and have a look. Thx again

Hi guys wondering if someone could offer some advice, I've just received a new prebuilt system from pcs using the h150i elite cap and the 5000d case. I'm just trying to set up fan curves and noticed something. The pump is set to cpu fan which I believe is correct, the fans for the rad are on fan ch3, I can change the rgb colours etc fine but for some reason if I change the rad fans to extreme for instance, only the centre fan speeds up, the 2 outer fans seem to be at a constant 600-800 rpm. I'd like to be able to control all 3 obviously for cooling purposes at higher loads. Any help would be appreciated. Thx