w.u.mejia89

FIXED!! It was so simple. I updated iCUE and LNP finally shows up under devices. Thanks for the your time though.

I just switched the SATA connector between the LNP and the COMMANDER CORE and the H50i is still recognized by iCUE. When I completely close iCUE all fans remained on including the RGB lighting.

With the device manager open I do not see a yellow triangle next to any of the devices listed. I swapped the two USB 2 connectors on the motherboard and the result remained the same. The iCUE still recognizes the H150i in the different port, but not the LNP most likely indicating the motherboard is good right? Since I bought two of the triple pack, I swapped out the LNP that came with the other set, but the result remained the same. I read somewhere that enabling the XHCI Handoff in the bios menu might work, but it didn't.

Also, I have created a wire diagram on how I wired the components.

The LNP does not show up on iCUE. I attached a screen shot of my iCUE. Shouldn't the COMMANDER CORE also show up iCUE? I've check my device manager, but how can you tell if there's an error?

I recently bought a Lian Li PC-O11DX 011 DYNAMIC case, 2 of the Corsair LL120 RGB Dual Light Loop 120mm Case Cooling Fan Kit with RGB Lighting totaling to 6 RGB fans, and a Corsair iCUE H150i ELITE CAPELLIX CPU Cooler with 3 ML120 RGB fans. With everything connected, iCUE recognizes the H150i ELITE CAPELLIX and the 3 ML120 fans, but not the 6 LL120 RGB fans. The 6 LL120's are connected to the corsair RGB fan hub. Fans 1-3 are connected to SYS_FAN2, SYS_FAN3, and SYS_FAN4 on the motherboard and fans 4-6 are connected to the fan ports 4-6 on the COMMANDER CORE that was provided with the H150i. The fan hub is connected to the Lighting Node Pro and the Lighting Node pro is connected to JUSB1 2.0 connector on the motherboard. The three ML120 fans are connected directly to the COMMANDER CORE ports 1-3 on both sides which is the RGB hub and fans. The COMMANDER CORE is connected to JUSB2 2.0 connector on the motherboard. ALL 9 fans are on and spinning. Can someone help me to get the iCUE software to recognize the 6 LL120 RGB fans. Thank you.