RAZORBLADEZ

Yes I powered the PWM hubs from a 12v molex. Just the Tach and PWM leads are going to the Commander Pro. So its ok to have a XD5 pump on both #5 and #6?

So I have 9 LL120, 4 LL140, 2 Hydro X pumps all connected to a commander pro. Can I plug two Hydro X Pumps into the Commander Pro? The manual says to only use port 6, I’m using 5 and 6. I haven’t got past filling the system and a short post test. Both pumps are running but can the commander handle both under load? Do I need a second commander?

For current build see my specs Dual Custom Loops 9xLL120 2xLL140 2xSP140 8x Hardline RGB Fittings various RGB strips and accents. I currently have the Commander Pro, 4x Node Pros and 4x RGB hubs Fans: Ch1: 3 way to CPU rad (3x LL120) Ch2: 3 way to GPU rad (3x LL120) Ch3: 3 way to 3x LL120 Ch4: 2 way to 2 LL140s Ch5: 2 way to 2 SP140s RGB: 13x Fans Will ICUE see the ones below: 6x RGB Loop fittings GPU Block CPU Block 2x Coolant reservoir 2x RGB strips With the Commanders 2 RGB ports and adding 2x Node Pros with 2 ports each theoretically I could have 6 hubs installed with 36 RGB channels right? All my RGB devices listed above have the same connector as the Corsair do. What is my best way to get all this Unicorn Puke synced? Also can I plug my loop temp sensors into the commander pro?