Jump to content
Corsair Community
0007.08 XR7 Front Mount
 

0007.08 XR7 Front Mount


DevBiker
 Share


Putting the XR7 in the front is certainly do-able but does have a set of challenges (of course) due to the thickness of the radiator.

XR7 360mm

This is what is shown in the photos. With the 360mm, you'll be able to have anything that fits in the top in push/pull as well as an XR5 in the side. You won't be able to fit an XD7 however - the pump housing won't clear the thicker radiator.

XR7 480mm

This will really limit what you can put in the top. You won't be able to use the XR7 360mm in push/pull (only a single layer of fans) nor would you be able to use the XR5 420mm. And you won't be able to configure push/pull on the front with a 360 in top either.

Finally, with the XR7, you won't be able to configure push/pull if you are using the standard PSU shroud; you'd need to drop down to 240mm to be able to do this. If you are using the low profile shroud - or you remove the shroud entirely - you'll have room for push/pull on the fans.

 

From the album:

DevBiker's Corsair 7000 Series Build Log and FAQ

  • 78 images
  • 0 comments
  • 5 image comments

 Share


Recommended Comments

There are no comments to display.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...