Nooradin Posted December 30, 2013 Share Posted December 30, 2013 I am currently using a H80i in corsair link with two Noctua NF-F12 PWM fans. The issue is that one of them is not recognized as a fully pwm fan and only a 3 pin, whereas the other one is recongized as a PWM fan and is allowing me to set the correct RPMs but the other one that is incorrectly shown as 3 pin will not go lower than 1000rpm. It was software related, after unintalling evrything it was finally recongised as 4 pin but now the fans wont spin at all and the h80i is not recognised in link and all there is a red LED, and on Boot I get the CPU Fan error which I did not used to get. I tried going back on the firmware from 1.0.7 to 1.0.5 has I was having issues with 1.0.7 but there were errors when trying to do so and it also crashed at the end when it successfully did so and then it began this. I think I may have bricked it but i'm unsure, is there any way to recover this? UPDATE - Switching the SATA power to the h80i the fans have starting to spin now (at their set custom rpms) but the h80i is not being recognised in corsair link at all and i am unsure if the pump is on. The LED is now flashing red and still getting CPU Fan Error on boot. UPDATE 2 - Temperatures are all normal and pump and fan are working as wanted but I am still recieving a CPU Fan Error on boot and also the LED on the pump is flashing red. I have completely uninstall corsair link and the drivers and reinstalled and it still isn't being recognised. Link to comment Share on other sites More sharing options...
This topic is now archived and is closed to further replies.