techuser Posted December 22, 2013 Share Posted December 22, 2013 I've got an H80i installed in a push/pull configuration. The only way I can get the fans to run at close to the same speed is to use the Corsair Link software and peg them to a specific RPM. Using 'Balanced' results in an RPM difference of 300 or more which I understand is not an efficient way to run the cooler. I updated the firmware and Corsair Link software to the current release (being sure to delete all the existing Link software and profiles before install the new release). The H80i components (pump and fans) are in the processor group. I guess my question is, is this normal, and if not, how can I correct it? Link to comment Share on other sites More sharing options...
wytnyt Posted December 22, 2013 Share Posted December 22, 2013 using the cpu as the target produces erratic results due to the cpu load varying so much.use the h80i water temp and setting a fan curve to trim each fan. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.