cut86ghmfer Posted November 23, 2013 Share Posted November 23, 2013 With 4930K, I would like to know, after first time boot to UEFI, all I have to do is go open XMP profile, then I'm ready to go, right? Or I go enter each Latency & voltage, I'm good to go? I only have little experience with tune timing, voltage before. I cannot find a 64GB kit 1600Mhz or I don't have to O.C. :D: I'm not pushing it to 2133 anyway, cos I would like to have more stable rendering for my 3dsmax or aftereffects. Thank you very much in advance. Link to comment Share on other sites More sharing options...
peanutz94 Posted November 23, 2013 Share Posted November 23, 2013 after first time boot to UEFI, all I have to do is go open XMP profile, then I'm ready to go, right? If you are going to run them at 1600mhz you may have to set them manually. There may not be an XMP profile for 1600mhz. If there is then , yes, just set XMP. Link to comment Share on other sites More sharing options...
cut86ghmfer Posted November 24, 2013 Author Share Posted November 24, 2013 thank you :biggrin: Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.