digits Posted November 21, 2013 Share Posted November 21, 2013 I recently installed my h80i and realized that the bolts that go into the backplate are bent after installation. How would I go about getting a replacement installation kit? It doesn't seem like I did anything wrong with the installation as the backplate was in the proper spot with the screws in the intel backplate aligned with the notches in the backplate. Seemed like when I installed the pump unit it was going in slightly crooked, so I think the bolts were bent from the time I received the unit. What should I do? Link to comment Share on other sites More sharing options...
Synthohol Posted November 21, 2013 Share Posted November 21, 2013 request an RMA with the link on the left. you can select the H80i but in the comments section explain you only need CW-8960010 (mounting kit) and your complete details so they can contact you if needed. good luck. Link to comment Share on other sites More sharing options...
digits Posted November 22, 2013 Author Share Posted November 22, 2013 Just sent an RMA request. Here's to hoping. I didn't even think you could RMA something like that, but I guess if it's broken it's broken, right? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.