someonewhy Posted October 8, 2013 Share Posted October 8, 2013 hey. i have 900d and when i am trying to screw the gpus i can't reach with my hands to the screwing holes?? Link to comment Share on other sites More sharing options...
peanutz94 Posted October 8, 2013 Share Posted October 8, 2013 Thats why they supply the angled screwdriver in the parts kit. Link to comment Share on other sites More sharing options...
someonewhy Posted October 8, 2013 Author Share Posted October 8, 2013 Thats why they supply the angled screwdriver in the parts kit. yes i know but the thing is even with the screwdriver i can't reach the screwing holes...the bolt is always falling down.... Link to comment Share on other sites More sharing options...
deees Posted October 8, 2013 Share Posted October 8, 2013 If it's any card except for the EVGA Classified's, there is a L-shaped Philips screw driver. For the Classified video card you should be able reach around the card, holding the thumb-screw betweenyour index fingers. Otherwise, you might want to pick up a flexible-shaft screwdriver kit. Link to comment Share on other sites More sharing options...
squidman Posted October 11, 2013 Share Posted October 11, 2013 Same issue here, due to shoddy quality control....just poor matching of screws to threads or not good enough machining basically. But then again, upping QC to higher tolerances probably would have made the case prohibitively expensive? (or not)...or it could be the powder coating that's making it impossible to screw in the the thumb-screws....general problem for most of the case.....dunno, not an engineer...pretty annoying tho'.... Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.