warface666 Posted September 30, 2013 Share Posted September 30, 2013 Hello all, new poster here but I need some help. I recently purchased the new 750D case and the H100i cooler. I purchased 2 sets of the sp120 fans to do a push/pull setup but I wanted to see what would you all do with the setup I have. The case has 2 140mm intake fans, 1 140mm exhaust. The GPU's I have use the ACX coolers so the air is exhausted into the case. How would you all configure this cooler to get the best performance? I will be over-clocking the cpu but not shooting for a crazy one, something around 4.4/5 stable. Do I even need to run it in push/pull? Any advice would be greatly appreciated before I get to work on this build. Link to comment Share on other sites More sharing options...
Ahtlon Posted September 30, 2013 Share Posted September 30, 2013 Look here http://forum.corsair.com/v3/showthread.php?t=122506 Push-pull is about 2 to 3 degrees cooler as push or pull only, put the fan's from the hdd drive bay on the front and remove the upper hdd drive bay and your good to go. Do you have enough room on top for push-pull, I thought it only could handle push or only pull at the top, or it could be I saw it wrong. Link to comment Share on other sites More sharing options...
warface666 Posted September 30, 2013 Author Share Posted September 30, 2013 That's a good question, I was under the impression it could but I haven't mounted it in the case quite yet to see what the clearance is. I'm kind of thinking I'm going to mount a set of fans on top of the RAD and have it pull cool air from outside the case and see how that works. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.