transdogmifier Posted September 27, 2013 Share Posted September 27, 2013 Hello all, Trying to attach an H50 to an LGA1150 board running Haswell 4770k I'm pretty sure it will work, but I'm darned if I can figure out how the heatsink will work. The bracket isn't tall enough (it sits too low) and the other round bracket makes no sense. Am I missing something? The instructions are pure gibberish. Anyone done this yet? Dan Link to comment Share on other sites More sharing options...
madmecca1975 Posted September 27, 2013 Share Posted September 27, 2013 Losen off the bracket that where the pump block fits so it's lose the put block in place then twist pump so it goes under the little lips on the ring then tighten up the ring Link to comment Share on other sites More sharing options...
Ahtlon Posted September 28, 2013 Share Posted September 28, 2013 Losen off the bracket that where the pump block fits so it's lose the put block in place then twist pump so it goes under the little lips on the ring then tighten up the ring Like the Manuel says. That's why I bought a H100, H100i, and H80i, no fussing with putting the cooler on your mobo and cpu. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.