Jump to content
Corsair Community

Limit rpm of h80i on bootup?


kentuckysh4rk

Recommended Posts

I assume you are talking about the fan noise here and the bios in most motherboards start the fans out at maximum speed and, after a few seconds, throttles them back to where they should be. My Intel mobo doesn't allow the initial boot speed to be controlled and there may be no way to limit the initial speed in your system either.
Link to comment
Share on other sites

If you are talking about the ramping up of fan speeds to full during boot of fans connected to the H80i then no. It is not built into the firmware/software for it to perform this way.

 

It is supposed to do this to verify max fan speeds.

 

I will say this behavior is annoying though and wish Corsair would implement a different way of handling this.

Link to comment
Share on other sites

This is how its supposed to be. The fans only spin at max speed for about 10 seconds anyway. Is 10 seconds that much of an annoyance to you?

 

That 10 seconds verifies the max fan speed and blows all the dust out of the radiator fins. If you started at low speed the dust will just stay in the fins hindering cooling performance.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...