itkg2711 Posted September 17, 2013 Share Posted September 17, 2013 hi guys ! I have been using SSD 450 hours, but the speed is reduced very slowly. after using toolbox to update the firmware, the speed does not change in this case the product is warranty? tks for help :biggrin: Link to comment Share on other sites More sharing options...
peanutz94 Posted September 17, 2013 Share Posted September 17, 2013 Have you tried wiping the drive? If not I would do so. then re-run ATTO. If it's still low and you would like to replace the drive, just use the link on the left to request an RMA. Link to comment Share on other sites More sharing options...
itkg2711 Posted September 18, 2013 Author Share Posted September 18, 2013 Thank you for the reply, I have cleaned by wiping SSD but ATTO speeds remain the same. Maybe I will do RMA. Tks again! Link to comment Share on other sites More sharing options...
Toasted Posted September 18, 2013 Share Posted September 18, 2013 Based on the screenshots, you only have 4% of free space left on the drive. If i remember correctly, i think there needs to be about approximately 25% of free space for the drive to run at its normal speed. Link to comment Share on other sites More sharing options...
itkg2711 Posted September 18, 2013 Author Share Posted September 18, 2013 Based on the screenshots, you only have 4% of free space left on the drive. If i remember correctly, i think there needs to be about approximately 25% of free space for the drive to run at its normal speed. I'm sure 4% of data used. mean that 96% empty Link to comment Share on other sites More sharing options...
Toasted Posted September 19, 2013 Share Posted September 19, 2013 How did you format the drive? Using the Window format tool or secure erase using Parted magic? Have you tried a different SATA data cable and port? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.