Vanquisher Posted May 30, 2013 Share Posted May 30, 2013 As Title. H80i firm 1.05 and 2.3.4816 stable link 2. When i try to set custom curve, work. (fan moved on cpu Group) Just restart the computer(with corsairlink2 open) and dosn't work nothing, custom curve doesn't work. Rpm stay always stable at 900/1000 rpm. I tried to update firmware at 1.07 but result is same. Doesn't work after windows restart. Link to comment Share on other sites More sharing options...
moonshadow88 Posted May 31, 2013 Share Posted May 31, 2013 I used to have the same problem, install new version (2.4), works pretty much better than the old one (2.3) Link to comment Share on other sites More sharing options...
Vanquisher Posted June 4, 2013 Author Share Posted June 4, 2013 Installed. No way, sometimes work, sometimes not, randomly at start work or not. Any suggestion? Link to comment Share on other sites More sharing options...
Toasted Posted June 5, 2013 Share Posted June 5, 2013 What are your set RPM for the custom curve? If they are lower than 800RPM, start from 800 onwards and see if that helps. Link to comment Share on other sites More sharing options...
Vanquisher Posted June 6, 2013 Author Share Posted June 6, 2013 http://imageshack.us/a/img24/586/custom1n.png Already set with 900 min. This software have some problems... meh::pirate:: Link to comment Share on other sites More sharing options...
Speed Posted June 6, 2013 Share Posted June 6, 2013 When i try to set custom curve, work. (fan moved on cpu Group) Not that it necessarily has bearing on the custom curve working or not, but it is recommended to group the fans with the pump/water block, not the CPU. The fans need to respond to the water temperature, not the CPU temperature. Essentially, doing it the way you are, the two are disconnected by an interleaved thermal dynamic. Link to comment Share on other sites More sharing options...
Vanquisher Posted June 6, 2013 Author Share Posted June 6, 2013 Not that it necessarily has bearing on the custom curve working or not, but it is recommended to group the fans with the pump/water block, not the CPU. The fans need to respond to the water temperature, not the CPU temperature. Essentially, doing it the way you are, the two are disconnected by an interleaved thermal dynamic. Costum curve based on pump temp is hard :( my pump go from 28° on idle and 30.6 on full load... so, make me and example for custum curve setting. I cant put 28.1 28.2 etc. Link to comment Share on other sites More sharing options...
wytnyt Posted June 7, 2013 Share Posted June 7, 2013 Costum curve based on pump temp is hard :( my pump go from 28° on idle and 30.6 on full load... so, make me and example for custum curve setting. I cant put 28.1 28.2 etc. you dont need to put 28.1,28.2 ect,,itll still raise in increments if you had just 2 points such as 28 800 29 1800 28 will be 800 28.1 will be 900 28.2 will be 1000 ext.. you need to doodle with it to understand how it all works. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.