Etalim Posted May 9, 2013 Share Posted May 9, 2013 Hi! A while ago, my little brother told me that he's headset didn't receive any charging. After a quick look at it, I discovered that the pins inside the Micro USB connector on the headset itself are broken and physically damaged. I take it that no warranties cover this damage, as it won't even do that in Norway, which where we as private consumers already have extremely good rights. Therefore, I see no point in returning for RMA. But I can also not see the point in throwing away a good headset if it is only the Micro USB connector that is broken. I therefore want to do a replacement myself. New Micro USB connectors are ready for order, I have all necessary tools and equipment available at work. The only thing I'd have to know, is how to disassemble the left ear cup and access the PCB on the inside without breaking anything. The only logical "entrance" I could find was taking off the ear muff and then use a flat head screwdriver to pivot the plastic out. I have not done this yet though, as I'm afraid of breaking something in the process. I request a disassembly manual on the headset. If I can do this, I will try to document the replacement process as good as I can. Note that as I see it, my only other option is to throw it in the garbage, where it will only contribute to the electronic waste. Thanks! ~ Etalim Link to comment Share on other sites More sharing options...
Toasted Posted May 9, 2013 Share Posted May 9, 2013 Unfortunately, there are no guides that tell you how to disassemble a V2000 headset as it will void the warranty. I'm not sure if you can get an RMA, But its best wait for RAM GUY to say whether you can or not before disassembling it. Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted May 9, 2013 Corsair Employees Share Posted May 9, 2013 I don't recommend you open it. We can replace it if the micro USB port was defective. Link to comment Share on other sites More sharing options...
Etalim Posted May 9, 2013 Author Share Posted May 9, 2013 I just spoke to my brother and had him remember when the connector was most likely to have broken. Our conversation concluded that the headset stopped charging after the plug had broken (taking into account that he was right about when the plug broke). Nevertheless, the plug is physically damaged and covered by no warranties. I've got access to a professional electronics lab, fully ESD-secure zone and top-notch equipment and tools. Voiding the warranty is of no concern to me nor to my brother; If I replace the connector and something happens to it afterwards, so be it. We'll have to pick up a new one. If I cannot get any guidelines on how to properly open it here, I will do my best and improvise. I hope you understand. Thanks! ~ Etalim Link to comment Share on other sites More sharing options...
Leprechaun003 Posted May 12, 2013 Share Posted May 12, 2013 Hey Etalim, I have the same problem! If you proceed, could you please reply to me with directions to do the same thing? It would be much appreciated! Thanks, Leprechaun003@yahoo.com Link to comment Share on other sites More sharing options...
Toasted Posted May 12, 2013 Share Posted May 12, 2013 It's better to PM him instead of posting your email here. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.