boozinator Posted May 6, 2013 Share Posted May 6, 2013 Hi, Kind of OCD question here, but in a perfect world, would would you (corsair employees,) say would be the ideal torque to put on each bolt of the H80i mounted to a 1155 socket? Thanks for any help. Link to comment Share on other sites More sharing options...
boozinator Posted May 7, 2013 Author Share Posted May 7, 2013 Anybody? Sure somebody has this on a white sheet somewhere. Link to comment Share on other sites More sharing options...
wytnyt Posted May 7, 2013 Share Posted May 7, 2013 ive never seen an actual torque value for it,ive always have been told to simply hand snug them down which is what has worked for me,i them hand check the block to see if theres any movement. Link to comment Share on other sites More sharing options...
boozinator Posted May 7, 2013 Author Share Posted May 7, 2013 ive never seen an actual torque value for it,ive always have been told to simply hand snug them down which is what has worked for me,i them hand check the block to see if theres any movement. Sounds reasonable to me. What throws me off is the Philips head they put on the nuts, it tempts me to over tighten, which prompted my torque question. Link to comment Share on other sites More sharing options...
peanutz94 Posted May 7, 2013 Share Posted May 7, 2013 I have never seen a torque rating either. They should be just snugged up good. I'm surprised to see the slots back. They removed them awhile ago because people were over tightening them and snapping the screws off. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.