uvazquez Posted April 10, 2013 Share Posted April 10, 2013 I have a system with 2 Corsair H80i units (one for each processor). Software "CorsairLINK 2" shows temperature and usage percent of each CPU plus two video cards, but it shows Temp, LED and Pump from ONLY ONE H80i unit. What do I do to get (and control) information from the second H80i unit? Regards. Link to comment Share on other sites More sharing options...
Speed Posted April 11, 2013 Share Posted April 11, 2013 According to other posts on this issue, specifically in the CorsairLINK forum, if was stated that only one Hydro would be seen. Later, Cool Guy set that straight and said that two would be detected and controlled. Link to comment Share on other sites More sharing options...
uvazquez Posted April 11, 2013 Author Share Posted April 11, 2013 Do you mean that it is no way to control both H80i? Link to comment Share on other sites More sharing options...
wytnyt Posted April 11, 2013 Share Posted April 11, 2013 Do you mean that it is no way to control both H80i? according to a post made by Coolguy [corsair rep] ,you should be able to control both Link to comment Share on other sites More sharing options...
uvazquez Posted April 12, 2013 Author Share Posted April 12, 2013 There is a detailed "Update Firmeware" instruction set in Corsair page, but I cannot find a link to dowanload the Firmware. Any Help? Link to comment Share on other sites More sharing options...
wytnyt Posted April 12, 2013 Share Posted April 12, 2013 There is a detailed "Update Firmeware" instruction set in Corsair page, but I cannot find a link to dowanload the Firmware. Any Help? h80I firmware is a sticky at the top of cooling,but here http://forum.corsair.com/v3/attachment.php?attachmentid=12219&d=1361765933 Link to comment Share on other sites More sharing options...
uvazquez Posted April 13, 2013 Author Share Posted April 13, 2013 I have upgraded to firmware 1.0.5 (February 2013) with the following results: 1. The temperature of both CPUs increased 2° C in idle time. 2. The noise of the fans also increased. 3. CorsairLINK2 software still shows fan, led and pump for only one H80i system. This action was only bad results in all points. Any idea about how to solve all this new problems, plus the original problem (of this thread)? Link to comment Share on other sites More sharing options...
uvazquez Posted April 15, 2013 Author Share Posted April 15, 2013 Where are the Corsair Technical Support engineers to provide a solution? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.