Jump to content
Corsair Community

FYI On Safely Remove Hardware and New Software


Recommended Posts

This is an FYI that I recently discovered.


This applies to the new software not the old as the old would block the removal all the time if it was loaded.


If I have my external SATA drive powered on and connected when I boot up the drive will not eject and I get a warning message in the event viewer stating that CorsairLINK_HardMointor.exe stopped the removal. If I turn the drive on after booting the drive will eject properly.

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...