Jump to content
Corsair Community

H80i bent standoffs (Intel 1155)


Recommended Posts



after installing the H80i four or five times I noticed that the rhumbscrews were not perfectly in place. After demounting I found the reason: The standoffs were heavily bent:




I'm pretty sure that I didnt't use excessive force to tighten the screws. However I was a little worried about the cooler plate not being firmly attached to the heatspreader. There always seemed to be a little gap which resulted in subpar temperatures.


Well the damage has been done no matter what. So where can I get these standoffs?


I've already opened up a case: #6001356


Thanks in advance,



Link to comment
Share on other sites

  • 2 weeks later...


This topic is now archived and is closed to further replies.

  • Create New...