ace2289 Posted March 11, 2013 Share Posted March 11, 2013 I just recently built a computer and I was very much pleased with the performance overall. However I could not get either of the two SSDs two run up to spec. I could only get 350MB/s read and 300MB/s write out on Crystal Disk Mark. I have already checked the motherboard, updated the BIOS, downloaded the latest drivers. In RAID 0 I am getting 700MB-760MB/s read. It almost seems like the speeds are not stable. Even extracting a file on the desktop from a zip file that is on the desktop seems to be fairly slow, never goes above 10MB/s. So I am starting worry. The firmware on the SSDs is 5.05A, however, the latest sandforce firmware on the forum shows 5.03. So I am little confused. I have tried different cables as well. So I would appreciate all the input. I am hoping it is something small I might have overlooked, but I have exhausted every nook and cranny trying to get the most out of my investment. Any and all suggestions would be appreciated. Note: Apparently it made a liar out of me and did EVEN WORSE this time on crystal disk mark. And the other issue I have had is the fact that it only lets me use 226GB in RAID 0 where as Intel Raid Management still recognizes it as two 119GB drive even though they are both 128GB drives. Thanks Link to comment Share on other sites More sharing options...
This topic is now archived and is closed to further replies.